Seat/ Chair blow molding machine

Seat/ Chair blow molding machine
The best know brand series, have a large amount of customers in worldwide; it is famous for excellence, practical results and classic
1. Mold open and clamping system adopt the gear wheel and rack in-phase aim at twin-shaft clamping device; 
2. Oil tank presses clamping mold;
3. Adopt X pull arm mold platen to increase rigidity of mold platen, pull arm bevel is 45°,the space for mold is large;
4. The extrusion system adopt frequency conversion controls the driving, the quantity of extrusion is large;
5. Adopt the PLC with Japanese Panasonic brand, the programmer is optimized, all of the electrical equipment adopt world famous brand.

HC90

技术参数(Technical Parameter)

●最大制品容积(Max.volume of products)-----------------------------------------------------------------------------------------60L

●挤出装置(Extrusion)

螺杆直径(Screw diameter)----------------------------------------------------------------------------------------------90mm

螺杆长径比(Screw length/dia. ratio)-----------------------------------------------------------------------------------25：1

塑化能力(Plasticizing capacity)--------------------------------------------------------------------------150 kg/h（HDPE）

机筒加热功率(Heating power)------------------------------------------------------------------------------------------25 KW

绞料电机功率(Driving power)------------------------------------------------------------------------------------------45 KW

●模头装置(Clamping system)

最大口模直径(Max.dia. of die) ---------------------------------------------------------------------------------------350mm

模头加热功率(Heating power of die)---------------------------------------------------------------------------------20 KW

储料缸容积(Volume of accumulator)---------------------------------------------------------------------------6L(8L选配)

●合模装置(Clamping system)

模板最大平面尺寸(宽×高)(Platen dimensions)(W×H)----------------------------------------------------900x800mm

合模力(Clamping force)-------------------------------------------------------------------------------------------------270 KN

模板开距(Max. platen opening stroke)------------------------------------------------------------------------400—1050mm

最大开合模速度(空循环) (Max.speed of clamping device)(idle cycle)--------------------------------------600PC/H

模具尺寸(宽×高)(Mold dimension)(W*H)-----------------------------------------------------------------700x1000mm

模具厚度(Thickness of mold)----------------------------------------------------------------------------------405—600mm

●液压系统(Hydraulic system)

小泵 (Small pump)--------------------------------------------------------------------------------------------------------16MPa

大泵 (Big pump)----------------------------------------------------------------------------------------------------------12 MPa

●泵油系统(Oil pump system)

油泵电机功率(Motor power of oil pump)------------------------------------------------------------------------------30 KW

壁厚电机功率(Motor power of parison thickness)---------------------------------------------------------------------4 KW

●电源(Electrical power)

电压(Power voltage)-----------------------------------------------------------------------------------------------------AC380V

频率(Frequency)--------------------------------------------------------------------------------------------------------------50Hz

线制(Connecting cable)--------------------------------------------------------三相四线制(Three phase four wire system)

总额定功率(Total rated power) ----------------------------------------------------------------------------------------124 KW