Special machine for PC barrel

It is the most famous series with the highest popularity. It is well-known to many customers all over the world for its excellence, pragmatic, classic. According to different demand, 25:1 and 30:1 extrusion systems and big die head are for choice. Clamping system adopts two-tie-bar type clamping device with gears and racks synchronously aligned; Cylinder clamps mold by direct pressure; It adopts one-piece mold platen with X-shaped pull arms to increase the bearing rigidity of mold platen; The bevel angle of pull arms is 45°, which makes a large mold area; The extrusion system adopts frequency control of motor speed, and the amount of extrusion is large; It adopts PLC programmable controller made by Panasonic of Japan, of which prorams are optimized; All electric equipments adopt world-famous products.

 

Machine Features:

It is specially designed for the production of PC pure water bucket. It can also produce various hollow blow molding products made of PC such as lampshades, bottles, pots, cans, barrels etc.

5. Adopt the PLC with Japanese Panasonic brand, the programmer is optimized, all of the electrical equipment adopt world famous brand

HFB82PC

技术参数(Technical parameter)

●最大制品容积(Max.volume of products)----------------------------------------------------------------------20L

●挤出装置(Extrusion)

螺杆直径(Screw diameter)--------------------------------------------------------------------------82mm

螺杆长径比(Screw length/Dia.ratio)-------------------------------------------------------25：1(30:1)

塑化能力(Plasticizing capacity)-------------------------------------------------------90 kg/h（HDPE）

机筒加热功率(Heating power)----------------------------------------------------------------------34kw

●模头装置(Clamping system)

最大口模直径(Max.dia. of die)---------------------------------------80(大模头big die head 130)mm

模头加热功率(Heating power of die)-------------------------------------------------------------8.7KW

储料缸容积(Volume of accumulator)----------------------------------------------------------------1.5L

●合模装置(Clamping system)

模板最大平面尺寸(宽×高)(Platen dimensions(W×H)-----------------------------------440x600mm

合模力(Clamping force)----------------------------------------------------------------------------210KN

模板开距(Platen opening stroke Max.)-----------------------------------------------------330-780mm

最大开合模速度(空循环)(Max.speed of clamping device)(idle cycle)

--------------------------------------------------------------------------------------------------------650PC/H

模具尺寸（宽×高）(Size of mold)(W*H)------------------------------------------------440X600mm

模具厚度(Thickness of mold)--------------------------------------------------------------350－420mm

●液压系统(hydraulic system)

大泵Big pump----------------------------------------------------------------------------------------12 MPa

●泵油系统Hydraulic pump system

油泵电机功率motor power of oil pump-----------------------------------------------------------45KW

壁厚电机功率motor power of wall thickness------------------------------------------------------4KW

●电源(Electrical power)

电压(Power voltage)-------------------------------------------------------------------------------AC380V

频率(Frequency)----------------------------------------------------------------------------------------50Hz

线制(Connecting cable)----------------------------------三相四线制(Three phase four wire system)

总额定功率(Total rated power)  ---------------------------------------------------------------  92kw

Online Inquiry

*

*

* SubmitReset